150 x 120 x 40 mm drawer organizer, 3x2 compartments, 3mm ply
A finger-jointed organizer that drops into a 150 x 120 mm drawer, 40 mm deep, split into 6 compartments. Cut it in 3mm plywood. Every joint is kerf-compensated for your machine, and the geometry is checked before you download it. If your drawer is a different size, change the numbers - that is the whole point.
8 parts, about 15 min of cutting on a creality_falcon_10w, in 3.0mm stock.
| Sheet | Part |
|---|---|
| 0 | bottom |
| 0 | wall_back |
| 0 | wall_front |
| 0 | wall_left |
| 0 | wall_right |
| 0 | divider_h0 |
| 0 | divider_v0 |
| 0 | divider_v1 |
What you get
An SVG, a DXF and a ready-to-run .gcode for every sheet, plus a one-page assembly sheet with the dimensions, the part list and the order to put it together. Finger joints and divider slots are already kerf-compensated for the machine above, so the parts seat with hand pressure rather than a mallet.
The G-code runs on a GRBL machine straight off the card - no LightBurn in the middle - at 350 mm/min, 80% power, 4 passes. Those are deliberately conservative starting numbers rather than a calibrated recipe for your plywood, and the file says so in its own header. Supervise the first run, or ignore the G-code entirely and open the SVG with your own settings.
Resize this to fit mine
Enter your own interior dimensions - same generator, your numbers, checked the same way before you pay.